How to Build a Smok Pen
How to Build a Smok Pen
The Smok Pen is a revolutionary vaporizing pen which allows for a write-to-write experience, even while you are away from home. This is due to the unique design of the pen. It has two tanks, one smaller compared to the other, that house the e juice and charged batteries. When the user wants to write, he just places the pen in to the smaller tank and places the ink in the chamber where it’ll be vaporized. He simply turns on the pen and writes as though he could be writing under a black mirror.
One of the biggest attributes of the Smok Pen is its ability to charge while it is on your own desk. The reason being the coils on the Smok Pen were created in a way to help keep the e juice from dripping onto the table or anywhere else. This is due to the 0.3-ohm coil that is placed in the Smok Pen. The 0.3-ohm coil ensures that even the slightest of air currents will not affect the writing process. Simply because the electronic circuitry has protection built in so that it will never be affected by extremely low voltage electric currents.
The Smok Pen can be charged internally with a charger or via the USB connection that is included with it. Because the electronic circuitry has a safety barrier built in, therefore there is absolutely no risk involved when charging these devices through the computer. The Smok Pen includes a charging capacity of sixteen 50 mah batteries, which is ideal for all pens that use a couple of batteries.
To keep the Smok Pen doing work for an extended time period it is important that you don’t overcharge the battery. Overcharging the battery will certainly reduce the voltage that is available and may eventually result in the device malfunctioning. Overcharging the Smok Pen may also affect the vaporizing process. In the event that you feel that your battery isn’t getting the vapor it will, remove the pen from the energy source and let it cool off for some minutes.
The fire button on the Smok Pen is situated at the bottom right corner of these devices. The fire button has an orange light, which indicates that it’s on. It is possible to press this button to activate the electronic heating element that will permit you to vaporize the oil. After you have done so you can remove the coil from the holder and stick it in to the holder and place the Smok Pen into the airflow chamber, that will cause the heating element to start heating up and burning off the wick.
Once the coil is taken off the holder the airflow chamber is ready for the sub-ohm cartridge. The coils are put inside the holder plus they get heated from the airflow. After they get hot they start to turn blue, which is Puff Bar Flavors the indication that it’s ready for the pen’s battery. Ensure that you place your sub-ohm in to the chamber before you push the fire button. If you don’t put the coil in to the airflow chamber then the oil will leak and cause the leaking of e-juice.
Before you put the battery in to the pen, you must make sure that you have disconnected each of the leads. Then you have to remove the Smok Pen’s cap and locate the leak or drip tip. You must clean this with a small cotton bud, so that you can get rid of the leak. Then reattach the cap back to the Smok Pen and you are prepared to place the battery into the pen.
The ultimate portion of the construction process is the adapter plate, which fits into the Smok Vaporizer’s USB port. This plate lets you charge your e-juice during your computer, so long as you have an adapter for USB connection. I really like this part as it allows me to charge my entire kit at once without fretting about running out of power or constantly running out of e-juice.